TP250 PTO

Infeed section

Operation: Horizontal funnel with yellow safety bar for forward, return and stop of feed rollers

Infeed opening, height: 260 mm

Infeed opening, width: 350 mm

Funnel opening, height (inside measure): 736 mm

Funnel opening, width (inside measure): 1100 mm

Infeed position: Parallel to driving direction

Feed rollers: 2

Feed roller position: Horizontal

Feed roller diameter: 225 mm

Feed roller pretension: 2 springs 8 mm

Feed roller drive: 2 x hydraulic in parallel

Hydraulic oil capacity: 25 litres

Infeed speed (maximum): 39 m/min

Integrated hydraulic system: Yes

Hydraulic pump: Fixed gearwheel pump

Bio-degradable hydraulic oil: Optional

Chipping system

Chipping principle: Disc chipper

Chipping angle: 90 degrees

TP OPTICUT: No

TP TWIN DISC: Yes

Number of blades/knives: 3

Cuts per round: 3

Blade/Knive gauge - minimum: 13 mm

Blade/Knive gauge - maximum: 13 mm

Rotor speed: 1000 rpm

Rotor diameter: 960 mm

Rotor weight: 266 kg

Transmission: Direct

Anvil/counter knife - horizontal: 1 reversible (Hardox)

Anvil/counter knife - vertical: 2 (Hardox)

Replaceable tub plate: Yes

Sliver breakers: No

TP CHIP KIT: Optional

Tub plate: Yes

Tractor mounting

PTO 1000 rotations per minute: Yes

PTO 540 rotations per minute: No

3-point linkage: Cat. 2

PTO shaft: Included, with free-wheel and friction clutch

PTO rotations per minute: 1000 rpm

Hydraulic outlets: No DA

Front mounting - PTO 1000 rotations per minute: No